Flow Behavior of Fresh Very High Strength Portland Cement Pastes

Flow behavior of fresh very high strength portland cement pastes prepared at various water/cement ratios was studied by using a rate-controlled coaxial cylinder viscometer (Rotovisko-Haake 20, system M5-osc., measuring device MV2P with serrated surfaces). The tests were performed under continuous flow conditions. Experimental shear stress and shear rate data were fitted very satisfactorily with various models, one of which has already been proposed by the authors. Excellent results were achieved also by applying the Quemada equation. In addition, the influence of two different commercial superplasticizing agents (Concretan RX and Ergomix 1000, the former based on polycyclic copolymers with modified structures, carrying hydroxylated side chains, and the latter on a modified polyacrylic resin) was studied with the aim of determining their optimum dosage and verifying the effectiveness by comparing rheological results with those obtained in a previous work on an ordinary portland cement. The use of superplasticizers modified rheological behavior of the pastes; however, no value of optimum dosage was found for any additive, but only a superplasticizer concentration range within which pastes presented very low values of viscosity. Moreover, both superplasticizers showed a greater effectiveness when added to HSPC pastes rather then the OPC ones formulated with the same water/cement ratio.